Thread the Motor Wires through the
Downrod Stand Cover,decorative cap,
Canopy and Downrod.
PAGE: 5 / 9
Collar
Downrod
Downrod
Hanger Pin
Collar Screws
Lock Pin
F A N C O
160310
Installation Steps :
Hanger Pin
Lock Pin
Hang the fan on Hanger Bracket, and
make sure the slot of hanger ball is
snapped into the chip of Hanger
Bracket exactly.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket face down.
Fig.1
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
Remove the Lock Pin and take off
the Hanger Pin.
Fig.3
Loosen the collar screws in part way.
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Fig.4
Motor Wires
Downrod Stand
Cover
Decorative Cap
Canopy
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it is locked into position.
Fig.6
Fig.7
Slot
Chip
Hanger Bracket
Collar
Canopy
Decorative Cap
Downrod Stand
Cover
Fig.5
Tighten the hanger bracket to the outlet box with two mounting screws.(
Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.
) Attach the safety cable hook to the ceiling, and make sure the safety
cable hook is covered by the fan canopy.
WARNING: Mount only to an outlet box marked "ACCEPTABLE FOR FAN
SUPPORT"!
Fig.5.
Fig.2.
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Safety Cable Hook
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
NOTE: The fan weight is 15.4 lbs (7kgs). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failing to do so can result in serious injury.
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
