Fig.1.
Fig.3
Fig.5
Fig.7
Take off the downrod pin from downrod.
Loosen the hanger ball screw, then take
off the hanger ball and pin.
Install the bulbs (included). See relamping
label at socket area or packaging for
maximum allowed wattage.
Fig.4.
Installation Steps:
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 24.4 lb (11 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Turn off the electric power at the
main fuse or circuit breaker box.
PAGE: 1 / 5
Gently attach the glass holder onto the
housing glass shade.
Glass Holder
Housing Glass Shade
Bulb Type B Max.15W
(included)
Socket
Thread the wires through the assembled
housing glass shade. Then attach the
assembled housing glass shade to the
fan fixture set by inserting the collar.
Adjust the housing glass shade to make
the reverse switch locate in the big notch
of the glass holder. (See Fig.9)
Fig.6
Housing Glass
Shade
Glass Holder
Big Notch
Fan Fixture Set
F A N C O
F A N C O
090622
Tighten the hanger bracket to the outlet box with two mounting screws. (
Make
sure the outlet box is securely installed so that it will be able to support
at least the fan weight.
)
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED
"ACCEPTABLE FOR FAN SUPPORT"!
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Fig.2.
Secure the glass holder to the collar by
using the set screw.
Fig.8
Collar
Screwdriver
Set Screw
Glass Holder
Housing Glass Shade
