aireRyder FN52238, Manual

PAGE: 3 / 5

Fig.20

Fig.21

Fig.22

Fig.23

Secure the canopy to the hanging 
bracket with canopy screws.
( Please keep the antenna out of the
 canopy to improve the effectiveness
of the received signal.) 

Fig.25

Fig.24

Tighten the blades to the blade holders 
by using the blade screws and washers.

Install bulbs (included). See relamping
lable at socket area or packaging for 
maximum allowed wattage.

Install the glass shade by screwing it 
onto the central fan fixture. (Make sure 
the glass shade is securely attached, 
but DO NOT over tighten.)

U / L

D / L

HI

LOW

OFF

MED

Install the battery to the transmitter. (9V, not included).
Turn on the electric power.
 Press "HI" button to operate the fan in high speed.
 Press "MED" button to operate the fan in medium speed.
 Press "LOW" button to operate the fan in low speed.
 Press "OFF " to turn the fan off.
 Press and release the "U/L" button quickly to turn on/off the upper light.
 Press and hold the "U/L" button to adjust the illumination of upper light 
 with the dimmer switch.
 Press and release the "D/L" button quickly to turn on/off the the lower light.
 Press and hold the "D/L " button to adjust the illumination of lower light with 
 the dimmer switch.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, 
DISCONNECT THE ELECTRICAL SUPPLY CIRCUIT TO 
THE FAN BEFORE INSTALLING LIGHT KIT.

R E M O T E  
        C O N T R O L

U / L

D / L

O F F

H I

M E D

L O W

Turn on the electric power at the
main fuse or circuit breaker box.

F      A      N                     C       O

F      A      N                     C       O

090622

Fig.19

Attach the loop at the end of the safety cable to the ceiling surface, 
then secure it with a flat washer and dry wall screw. Make sure the 
flat washer and dry wall screw are covered by the fan canopy.

Flat Washer

Safety Cable

Bulb Type B Max.60W
          (Included)

Dry Wall Screw

Ceiling

Hanger Bracket

Ceiling Joist

Wood Member

(2" x 4" Approx.)

Junction Box

WARNING:

As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve 
energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190
Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current 
demand. Turn off power to the fan and replace the light bulbs with lower wattage bulbs.Turn on 
power to the fan, using the pull chain, wall switch, or remote control (whichever is installed on the
particular fan).