Setting and cleaning wipes
Put the wipe support
(3)
in front of you
Figure 6
, then position the pad in place taking care
to keep even the entire length, then press the entire surface to increase the effect of
scraping.
The change of wipe will simply be made by tearing it off
Figure 7
.
Wipes should be replaced regularly during work according to their cleanliness. We cannot
give you an idea of the rate of change, it varies and it is at your sole discretion. These
wipes are machine washable. You do not have to iron or use fabric softener or bleach, and
do not put in dryer.
Charger
•
The charger must not be exposed to direct sunlight, fire, or heat, as there is a risk of
explosion.
•
Never insert objects into the charger socket.
•
In case of unexpected loss or destruction of your charger, do not use any other charger
than the original. Contact your supplier immediately. Otherwise any other charger with
the same characteristics would likely destroy your device.
•
Never attempt to repair the cable from your charger. If it is damaged, replace it.
•
Before you connect your charger, make sure the voltage of your power outlet is the
same as indicated on the label.
•
Never unplug the charger by pulling the cable but take care to grasp the plug. It is
advised to store your charger in dry area between 5°C and 40°C maximum.
•
Never open your charger, potentially harmful substances may emerge and affect your
health, and short-circuit is always possible.
Battery charge level
Your appliance is equipped with 2 safety systems: one is the battery and the other is
the electrical circuit. They cut the battery when necessary so as not to over
