80001028
– Issue 1 10/21
3
1.0 General Information
Section 1 contains essential information about the operation of the unit, warnings and safety,
warranties, regulation guidelines, intended use, receipt, storage and shipping of the unit.
1.1 Safety Information
All essential safety information must be followed! A typical example of how a safety critical
warning is given will be displayed below. Typically, these are displayed In red box, however
there is no guarantee every user safety warning will be displayed in the same way. Use
common sense and good judgement and never install or operate the unit if not properly
qualified to do so.
Special Regulations apply for use, connection, operation, transportation, and maintenance.
Consultation is needed in case of any doubt about the requirements to safely carry out work.
Consult the relevant regulations and health and safety standards of your organization or
seek expert advice. When carrying out maintenance, repair, installation, and any other work,
Airflow Developments recommends the following safety equipment be used:
•
Protective glasses to protect against eye injuries.
•
Ear protectors to protect against all kinds of noise.
•
Hair net and protective clothing to guard against contact with moving parts. Do not wear
rings, chains, or other jewellery.
•
Protective mask protects the airways from small particles, dust, pollen, bacteria, and
viruses.
•
Protective gloves serve to protect the hands against rubbing, abrasions, cuts or more
injuries, as well as contact with hot surfaces.
•
Protective footwear serves to protect against heavy falling parts and from slipping on
slippery surfaces.
Danger:
Always pay close attention to danger and warnings signs. To not
do so could cause serious personal injury, death, and damage to the
product and property.
Warning:
For all work on the Purigo T1750 and T2200, the applicable
general safety at work and accident prevention regulations must be
observed! The following must be observed before all cleaning and
maintenance work or before opening the terminal compartment:
1.
All safety features like fuses, etc. must be correctly fitted and can
only be removed for maintenance and repair jobs by skilled and
authorized service engineers. Isolate the unit from the mains power
supply and secure against unintended restart!
– The rotating parts
must first come to a standstill!
– Once the rotating parts come to a
standstill, a waiting time of 5 minutes must be observed, as
dangerous voltages may be present due to internal capacitors, even
after isolation from the power supply!
2.
All plant-related safety regulations must be observed! If applicable,
further country-specific regulations must also be observed!
3.
Protection against contact must be ensured pursuant to BS EN ISO
13857:2008 when installed! Contact with rotating parts must be
avoided.
4.
A uniform inflow and free outlet must be ensured!
