3.6 Installation diagram / Fitting the unit
6
1. Pull the green front cover off the six Velcro fixings.
2. Place the unit flat on the floor and unscrew the four stud retaining screws - keep screws safe.
3. Without damaging the rubber seal, separate the moulded top half of the unit from the bottom
half by pulling the casing straight forward.
4. Unscrew the four forward protruding studs and keep safely.
5. Stand unit upright to separate the metal wall mounting plate from the bottom half of the casing.
Pull the casing forward leaving the rear protruding studs attached to the metal back plate.
6. Secure the metal base plate with the rear studs still attached to the wall.
7. Re-assembly of the unit to the wall mounted back plate with the protruding studs is the reverse
of the removal procedure.
12
Summary of Contents for Duplexvent DV72
Page 11: ...Figure 4 Electrical Diagram 11...
