Chair Basics
FRONT RIGGING
Installing the swing-away footrest
1. Turn the footrest to the side (open footplate is perpendicular
to wheelchair).
2. Install the hinge plates onto the hinge pins on the wheelchair frame.
3. Push the footrest towards the inside of the wheelchair until it locks
into place.
4. Repeat STEPS 1-3 for the other footrest assembly.
5. To release the footrest, push the footrest release lever inward, rotate
footrest assembly outward and lift the footrest assembly off the hinge
pins.
NOTE - The footplate will be on the inside of the wheelchair when
locked in place.
Adjusting the swing-away footrest
1. Remove impact guards and/or calf strap, if necessary.
2. Loosen, but do not remove the bolt & locknut that secure the lower
footrest sub-assembly to upper footrest support.
3. Reposition the lower footrest sub-assembly to the desired height.
4. Securely tighten the bolt & locknut.
5. Repeat STEPS 1- 4 for the other footrest, if necessary.
6. Replace impact guards and/or calf strap, if necessary.
7. Reinstall the swing-away footrest assembly.
WARNING:
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware
is tightened securely otherwise injury or damage may result.
!
10
11
