Installing the swing-away elevating leg rest
1. Place the elevating leg rest assembly on the outside of the wheelchair
and install the hinge plates onto the hinge pins on the wheelchair frame.
2. Rotate leg rest assembly toward the inside of the wheelchair until it
locks in place.
3. Repeat STEPS 1-2 for the other leg rest assembly.
NOTE - The footplate will be on the inside of the wheelchair when the leg
rest is locked in place.
4. Once seated in wheelchair, adjust the footrest to correct height
by loosening the locknut and sliding the lower footrest tube up
or down until desired height is achieved.
5. Tighten locknut securely.
6. To release the leg rest, push the leg rest release handle toward the inside
of the wheelchair (facing the front of the wheelchair) and swing the leg rest
assembly to the outside of the wheelchair.
Adjusting the swing-away elevating leg rest
1. To adjust the elevating leg rest, raise legs until the desired height
is obtained.
2. To reposition leg rest to normal position, support leg with one hand
and push release handle downward with the other hand.
3. To adjust the calf pad, turn the pad towards the outside of the wheelchair.
4. Slide the calf pad up or down until the desired position is obtained.
5. To secure the calf pad, turn the calf pad towards the inside of
the wheelchair.
!
WARNING:
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware
is tightened securely otherwise injury or damage may result.
12
13
