AdJUSTING THE WHEEL LOCKS
1. Ensure the wheel-lock is in the open (unlocked) position.
2. Loosen the bolt & locknut that secure the wheel-lock to the
wheelchair frame.
3. Adjust the position of wheel-lock until the measurement between the rear
wheel and the wheellock shoe is between 1/4 and 13/32 inches.
4. Securely tighten the bolt & locknut.
5. Engage the wheel-lock and push against the wheelchair to determine if
wheel-lock engages the wheel-lock shoe enough to hold the wheelchair.
6. Repeat the above procedures until the wheel-lock holds the wheelchair.
SIDE
FRAME
1/4” - 13/32”
(6.4 - 10.3 mm)
WHEEL-LOCK
SHOE
WHEEL-LOCK
HANDLE
BOLT & LOCKNUT
UNLOCKED
POSITION
PULL TO LOCK
LOCKED
POSITION
TO REMOVE DETACHABLE DESK ARMS (IF APPLICABLE)
1. Push in the button lock at the front base of the arm.
2. Lift the arm up and off.
TO REPLACE DETACHABLE DESK ARMS (IF APPLICABLE)
1. Reposition the arms.
2. The button lock will automatically snap in place.
14
15
ChANGING SEAT-TO-FLOOR HEIGHT
1. Remove the rear wheels from the wheelchair and reinstall
to desired height.
2. Remove the front casters from the wheelchair and reinstall
to desired height.
If applicable, adjust anti-tippers according to new seat-to-floor height.
24” REAR WHEEL
(AXLE POSITION)
TOP
BOTTOM
8” WHEEL
FRONT FORK
(AXLE POSITION)
TOP
MIDDLE
BOTTOM
LOCKNUT
M12
HUB CAP
HEX BOLT
M12 X 110 MM
FRONT FORK
LOCKNUT
SPACER
BOLT
