42
Mounting the Remote Sensor (Wireless)
1.
Disconnect the controller wire from the side of Wine
Guardian unit and save for future use.
2.
Plan on mounting the remote sensor on a solid surface
away from doors, corners, air outlets, drafts or heat
generating equipment. Do not mount the remote sensor
directly on an outside wall, wall adjacent to a boiler
room, or other hot area as this runs the risk of
influencing its temperature readings. The recommended
height is four to five feet above the finished floor.
3.
Remove the sensor face plate (Fig. 1). Mark the
mounting points at the desired location within the wine
cellar (Fig. 2).
4.
Drill two one-eighth inch holes and insert anchors
within the mounting surface. Anchors may not be
required if securing to a wall stud or racking system.
Insert screws to secure the sensor to the wall to ensure it
mounts easily onto the two screws and slides down onto
the slotted openings freely.
5.
Input the three AA batteries. (Fig. 3)
(only applicable with wireless installations)
6.
Pair the sensor with the unit
(See Page 46 for Pairing Instructions)
NOTE: Once Paired the Remote Interface’s
readings will be included into the system’s
temperature and humidity averages.
7.
Mount the Remote Sensor on the wall (Fig. 4)
8.
Reattach the sensor’s faceplate (Fig. 5)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Summary of Contents for WINE GUARDIAN CAB018
Page 14: ...14 CAB018 Cabinet Unit...
Page 15: ...15 CAB018 and CAB25...
