Connection Status -
z
Connection – This column show current connection status. If AP already
connect to an Access Point or station, here will show the MAC address of
the associated Access Point or station. Otherwise, connection column will
show “N/A” which means no connection to any Access Point or station.
z
Network Type – Here indicates the Access Point works in AP mode or
Client mode (Infrastructure mode / Ad Hoc mode)
z
SSID – SSID column displays current SSID assigned to the AP
z
Wireless Mode – Here show the Access Point current work in either 11b
or 11g mode
z
Current Channel – This column indicates the radio channel currently in
use.
z
Security - Here indicates AP security settings in client mode. Should be
either “Disabled”, “WEP” or ‘WPA-PSK”.
z
Link Quality – This column shows current link quality with AP by signal
strength in 0 to 100 percentage scale.
Wireless Network -
z
Network Mode – You can set the wireless client into 2 different modes by
clicking radio button. Wireless Client (Infrastructure) act as an AP client
while Ad-hoc can support peer to peer network. Both Infrastructure and
Ad-hoc can support up to 108M SuperG transmission.
z
Wireless Mode - Default setting is “2.4GHz 54Mbps (802.11g)”. This
will support all 802.11b/g clients connect to the AP. You can choose
38
Summary of Contents for AAP-24005g
