Chapter 7. Web Interface Configuration
AirLive MW-2000S User’s Manual
133
7.3.2 AP Discovery
Use this function to detect and manage all of the APs in the network segments.
y
To discover AP manually, please fill in the required data.
¾
Interface:
Check
Private LAN
or/and
LAN1~4
and enter the
Base IP
and
Pool Size
(the discovered APs
will be configured to use IP address among the pool).
¾
AP Access:
Input the
IP Address Range
(the default is 192.168.2.1/192.168.2.1),
ID
(the default is
admin) and
Password
(the default is 1234) of the AP.
Then click the
Discover
button and the APs match the given settings will show in the list below. If one of the IP
addresses intended is used, a warning message will show up. In this case, please change the IP range on Base
IP or Pool Size and then click
Discover
again. Input the desired name and password for the AP. Select one
template, and then click
Add
to add it under the managed list. (About the template, please see 5.3.4 Template).
When the matched AP is discovered, it will show up in the list below and be given a new IP address set here (ex:
192.168.2.2). Check the
Add
box to add the AP and it will be listed to the AP list. When an AP is added, its MAC
address will be automatically recorded into MAC Privilege List (please see 5.4.2 Privilege List) so its
management page can be accessed.
Click Configuring to go on the related configuration. For the details, please refer to
5.3.1 AP List
.
Summary of Contents for MW-2000S
Page 1: ...MW 2000Sv2 Hotspot Management Gateway User s Manual ...
Page 23: ...Chapter 4 Basic Hotspot Configuration AirLive MW 2000S User s Manual 18 Setup Flow ...
Page 33: ...Chapter 5 Multi Service Providers AirLive MW 2000S User s Manual 28 Setup Flow ...
Page 58: ...Chapter 6 Multi Service Zones AirLive MW 2000S User s Manual 53 Setup Flow ...
