AirLive
POE100CAMv2
User’s
Manual
42
6.2.2 SNMP
Set the SMTP menu when you want to send an image via e-mail. By using Mail (SMTP) function, you can
send a mail with attached image which has been shot linked with the external sensor input or with the built-in
motion detection function. The image file can also be sent periodically. E-mail (SMTP) setting menu is
composed of three tabs,
General
,
Alarm sending
and
Periodical sending
.
6.2.2.1 General
Select On when you use the SMTP function. The common setting options are displayed below. If you do not
wish to use the e-mail (SMTP) function, select Off and click OK.
Note
：
• During transmission of an image file via mail, the frame rate and operation performance of the monitor
image of the main viewer decline.
• While the camera video mode is set to
MPEG4
, the image of the composite video signal output from
the video output connector of the camera may be distorted during mail transmission.
• You cannot send an audio file by using the mail sending function.
SMTP server name
：
Type the SMTP server name up to 64 characters, or the IP address of the SMTP server.
Authentication
：
Select the authentication required when you send an e-mail.
Off:
Select if no authentication is necessary when an e-mail is sent.
On:
When authentication is necessary an e-mail is sent, select one of the authentication methods from the
followings.
