AirLive
POE100CAMv2
User’s
Manual
48
6.2.5 Motion
Detection
When you click
Motion Detection
on the Advance mode menu, the Motion Detection setting menu appears.
There are three Motion Detection functions as sensors to set for different detecting zones. Each one has
Threshold and Sensitivity inputs which you can adjust to specific zone sequentially. Motion Detection function
can support to FTP, SMTP and Alarm output for capturing and sending images or starting alarm output.
Click it
On
when you use the Motion Detection function and detecting zone appears for adjusting and moving.
The common setting options are displayed below. If you do not wish to use the Motion Detection function,
click it
Off
and press
OK
.
Motion Detection 1
：
Click it on for using
Motion Detection 1
function as a sensor. You can adjust and move
the detecting zone by using mouse.
Motion Detection 2
：
Click it on for using
Motion Detection 2
function as a sensor. You can adjust and move
the detecting zone by using mouse.
Motion Detection 3
：
Click it on for using
Motion Detection 3
function as a sensor. You can adjust and move
the detecting zone by using mouse.
Threshold
：
You can use the tool bar to set up-limit value. When detecting zone signals are over setting value,
it would carry on assigned work.
Sensitivity
：
You can use the tool bar to set down-limit value. When detecting zone signals are over setting
value, it would carry on assigned work.
Carry out the following steps
：
