- 27 -
For example, when you enter
192.168.1.50/192.168.1.80
in
Start/End IP Address of Accept IP Address and then click Add,
the user whose IP address located within
192.168.1.50 ~
192.168.1.80
will be allowed to access the camera. On the other
hand, if you enter the IP range in Start/End IP Address of Deny
IP Address and then click Add, the user whose IP address located
within the range will not be allowed to access the camera.
To remove the assigned range of IP addresses for IP Filter, select
the setting in the Accept/Deny IP List and then click Delete.
4.3.4 Network >> IP Notification
In case the IP address is changed, system is able to send out an
email to alert someone if the function is enabled.
SMTP Notification (e-mail): If enable this function, then the “Send
to“ and “Subject” fields need to be filled.
Send To: Type the receiver’s e-mail address. This address is used
for reply mail.
Subject: Type the subject/title of the E-mail.
TCP Notification: If enable this function, then the “TCP Server“,
“TCP Port”, and “Message” fields need to be filled.
TCP Server: Type the server name or the IP address of the TCP
server.
TCP Port: Set port number of TCP server.
Message: The message will be sent to FTP server.
HTTP Notification: If enable this function, then the fields below
need to be filled.
