AirLive SNMP-FSH2602MG User’s Manual
32
Aggregator setting
Figure 4-12 Trunking
System Priority:
A value used to identify the active LACP. The switch with the lowest
value has the highest priority and is selected as the active LACP.
Group ID:
There are seven trunk groups to provided configure. Choose the "group id"
and click "Get".
LACP:
If enable, the group is LACP static trunking group. If disable, the group is local
static trunking group. All ports support LACP dynamic trunking group. If connecting to
the device that also supports LACP, the LACP dynamic trunking group will be created
automatically.
Work ports:
Allow max four ports can be aggregated at the same time. If LACP static
trunking group, the exceed ports is standby and able to aggregate if work ports fail. If
local static trunking group, the number must be as same as the group member ports.
Select the ports to join the trunking group. Allow max four ports can be
aggregated at the same time.
If LACP enable, you can configure LACP Active/Passive status in each port on
State Activity page.
Click
Apply.
Aggregator Information
Clicking on the Aggregator Information will show the state of the aggregator. Three
different screens can be shown to indicate the different status:
