AirLive SNMP-FSH2602MG User’s Manual
64
Port Configuration
This page can change every port status.
Press Space key to change configures of per item.
InRate
(100K/unit):
User can set input rate control, per unit is 100K. The valid range is 0~1000.
0: disable rate control.
1~1000: valid rate value.
OutRate
(100K/unit):
User can set output rate control, per unit is 100K. The valid range is 0~1000.
0: disable rate control.
1~1000: valid rate value.
Enabled
:
User can disable or enable this port control.
“Yes” that mean the port is enable.
“No” that mean the port is disable.
Auto
:
User can set auto negotiation mode is “Auto”, “Nway_Force”, “Force” of per port.
Spd/Dpx
:
User can set “100Mbps” or “10Mbps” speed on port 1~port 24,
set “1000Mbps”, “100Mbps” or “10Mbps” speed on port25~port26 (depend on
module card mode), and set “full-duplex” or “half-duplex” mode.
Flow Contro
l:
Full: User can set full flow control function (pause) as enable or disable.
Half: User can set half flow control function (backpressure) as enable or disable.
NOTE:
Pressing <Save> only can save one page configuration.
If the static trunk groups exist, you can see it (ex: TRK1, TRK2…) after port 26, and
you can configure all of the items as above.
