Step 3:
Type the “ipconfig” and press the “Enter”. Then the following message
should be found. Check the IP address, Subnet Mask, and Default Gateway
addresses are same as previous setting. If same, you are successful to set up
the network configuration.
2.2.3 Wireless Connection
Follow the steps below to connect to the
AirLive WMU-6000FS
in a wireless
environment. We assume that there is at least one WLAN card installed on
your computer, and AP Storage is powered on
Step 1:
Enabling the WLAN card first, and check the
Wireless Network
Connection
properties from
My Network Places.
Step 2:
Select the
Wireless Networks
icon after entering the “
Wireless
Network Connection Properties
”. You will find the
WMU_6000FS
in the
Available networks
, then select the
WMU_6000FS
, and click
Configure
to
connect.
AirLive WMU-6000FS User’s Manual
22
Summary of Contents for WMU-6000FS
