AirLive WMU-6000FS User’s Manual
43
ion: In a network, the maximum size or length of a
fragment is determined by the protocol used to transport the data.
This value should remain at its default setting of
2346
. If you
experience a high packet error rate, you may slightly increase your
"Fragmentation" value within the value range of
256 to 2346
,
even
number only
. Setting the Fragmentation value too low may result in
poor performance.
z
DTM interval: A Delivery Traffic Indication Message (DTIM) is a
countdown informing clients of the next window for listening to
broadcast and multicast messages. When the Access Point has
buffered broadcast or multicast messages for associated clients, it
sends the next DTIM with a DTIM Interval value. AP clients hear the
z
Press “N
z
Fragmentat
beacons and awaken to receive the broadcast and multicast
messages. Enter a value from
1
to
255
for DTIM. The default value
for DTIM interval is set to
3
.
z
Preamble Type: The Preamble Type defines the length of the CRC
(Cyclic Redundancy Check) block for communication between the
Access Point and roaming wireless adapters.
SSID
Broadcast:
Enable
or
Disable
a SSID broadcast. When
enabled, the SSID of
WMU-6000FS
is sent to wireless enabled
devices on the LAN.
ext” button, you could see the Wireless MAC Filtering setting.
Summary of Contents for WMU-6000FS
