2. Maintenance
2-13
2.9
Clean the Strainer Provided inside the Engine Feed Pump
●
To each 500Hr, remove the strainer
“
2
”
inside the
joint bolt
“
1
”
fitted at the inlet side of the feed pump
and clean it.
●
Remove the strainer
“
2
”
by loosening the joint bolt
“
1
”
and clean it with diesel fuel oil, and also using
high air pressure blow. At this time be sure to
replace gasket
“
3
”
.
Then after finishing all cleaning jobs, install it again
in reverse steps.
2.10
Supply Grease to Trailer Hub Bearing
●
When replenishing grease to the trailer hub bearing,
contact our office nearby or distributor.
Grease: Chassis grease
2.11
Supply Grease to Leaf Spring Pin
●
Supply grease through grease nipples positioned at
the bottom.
Grease: Chassis grease
2.12
Check and Confirm that the Fixing Bolts for the Drawbar are
Properly Tightened
●
Check and confirm once every three months that the
bolts with which drawbar is fixed are not loosened.
(8 points)
●
If it is found that specified tightening torque of
clamped bolts drops to a lesser value, retighten them
to correct specified value.
A120067
2
1
3
TR0260-1
Bearing
Grease
Hub
TR0260B
A120201
Tightening torque:
3,053lb
・
in(345N
・
m)
[3,450kgf
・
cm]
Discount-Equipment.com
Summary of Contents for PDS400S-6C3
