3.Operation
3-16
3.4.4
Operating procedures when engine fails to start up on first attempt
If the engine fails to start after following steps 1 through 4, set the CONTROL POWER switch to the
position and wait 1 minute before attempting the steps again.
If the repeated procedure does not allow the engine to run, the following causes are suspected.
Therefore, check the following items.
No fuel
Lack of air bleeding in fuel line
(See 3.4.8)
Clogging of fuel filter
Discharge of battery (Low cranking speed)
If you do starting manipulation successively, the starter will not stop fully and it causes
damages to pinion ring gear and breakdown of the starter.
3.4.5
Operation in cold weather
Use engine oil of a viscosity that meets the ambient temperature according to 3.2.1.
Use LLC (antifreeze). Use correct amount to provide freeze protection, according to the ambient
temperature.
Battery should always be kept fully charged.
When operating in cold weather be sure to change engine oil and coolant according to
outside temperature.
Go
to
Discount-Equipment.com
to
order
your
parts
