5.Periodic inspection/Maintenance
5-18
5.5.20
Clean inside of fuel tank
Every 2,000 hours
When cleaning inside of fuel tank it, contact our office nearby or distributor because technical
knowledge is required.
5.5.21
Change nylon tubes
2,000 hours or every 2 years
Replace nylon tubes used for the oil and air piping’s. When replacing it, contact our office nearby or
distributor because technical knowledge is required.
5.5.22
Change fuel hose
2,000 hours or every 2 years
In case various rubber hoses for fuel system and engine lubrication system are hardened or
deteriorated, replace them even before the specified replacement time.
When replacing hoses, contact directly us or distributor because it requires expert technical
knowledge.
5.5.23
Change rubber hose
2,000 hours or every 2 years
Check hoses used for oil piping for any crack or tear, and replace when an abnormality is found.
When replacing hoses, contact directly us or distributor because it requires expert technical
knowledge.
5.5.24
Change DEF pump filter
Every 3,000 hours
<Procedure>
1.
Set the CONTROL POWER switch to
position.
Wait at least 2 minutes to ensure the supply module
[A] has fully stopped.
2.
Place an oil pan under the supply module, loosen the
cover [B] and pull it out together with the filter [C].
3.
Install new filter [C].
(For part number, See 5.4)
4.
Install cover [B] and tighten.
A180477
B
C
A
The DEF filter acts as an important
step in filtering small particulate matter
from the system. To ensure the long
life of the unit, it is important to use
genuine replacement parts.
Go
to
Discount-Equipment.com
to
order
your
parts
