10
BEFORE USE
Before connecting your compressor to the power supply, check the following:-
• Set the ON/OFF switch to the
OFF position (pushed down).
• Make sure that the compressor
is on level ground.
• Make sure that the supply
voltage matches the voltage
shown on the data label.
CHECK THE OIL LEVEL
1. Make sure the oil level is half way
up the sightglass.
2. If not, remove the oil cap and add
oil to the crankcase.
•
Only use SAE30 compressor oil,
available from your dealer.
•
Only fill to the halfway point on the
sightglass. Overfilling may result in
damage.
