Outlet box
Canopy
cover
Canopy
Hanger
bracket
Figure 9
Screws
6.
Finishing the Installation
Step 1.
Tuck connections neatly into ceiling outlet
box.
Step 2.
Slide the canopy up to mounting bracket and
place the key hole on the canopy over the screw on
the mounting bracket, turn canopy until it locks in
place at the narrow section of the key holes. (Fig. 9)
Step 3.
Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws.
Note:
Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
MAKE SURE THE NOTCH ON THE HANGING
BRACKET PROPERLY SITS IN THE GROOVE IN
THE HANGER BALL BEFORE ATTACHING THE
CANOPY TO THE BRACKET BY TURNING THE
HOUSING UNTIL IT DROPS INTO PLACE.
Attaching the Fan
Blades
NOTE:
Your fan blades are reversible. Select the
blade side finish which best accentuates your
decor.
Step 1.
Attach the blades to the blade arms using
three screws and fiber washers as shown in Figure
10. Start a screw into the arm, do not tighten.
Repeat for the 2 remaining screws and washers.
Step 2.
Tighten each screw securely starting with
the center screw. Make sure the blade is straight.
Step 3.
Fasten the blade assembly to the motor
using the motor screws provided. (Figure 11)
Figure 11
Figure 10
Motor
Blade assembly
Screws
Fiber
washer
Blade arm
Blade
Screws
