Page
4
of
7
7.
The top part of the frame is thinner than the bottom one. It consists of two similar parts (fig. 9) that
need to be joined together and fixed with a screw as seen on fig. 9 and fig. 10.
Fig. 10
8.
Then insert them in the corresponding hole on both sides, (fig.11) so you have a completed metallic
frame.
9.
The completed metallic frame should look like this - fig:12
Fig.12
10.
Next you will need to assemble the rear supporting legs of the frame. These legs are made out of two
parts:
Fig. 9
Fig. 11
