3
Installation, Operation & Maintenance M
fgfgffhfgfggbffgfV11:0212212121
HEALTH & SAFETY
Water Treatment
Check for any treatment that is required to the water supply for prevention of
corrosion and scaling of eq
be taken can be obtained from the relevant Water Supply Authority, particulars of
which can be found in the Waters Engineers Handbook yearly edition.
Cautionary Notes
No part of the unit shall be dismantled until a careful study has been made of this
manual.
This manual deals in detail with erection, commissioning, and servicing, and shall be
strictly adhered to. Wherever any maintenance
interior shall be left clean and all access panels and guards shall be correctly
fastened.
General
This section deals with the hazards that could be encountered when any work is
carried out on the equipment for which this manual is written. Therefore the
following points should be observed to avoid any injuries or health hazards.
The installation of the unit shall be checked to ensure that:
A suitable electrical supply is connected.
Prior to entry to any section please ensure that the electrical supply
isolated either at the control panel or at the incoming mains. Please note
that if the control panel isolator is switched off the incoming side of the
electric supply will remain live. DO NOT enter the unit while the fans are
running. After isolating t
to stop prior to removing fan covers.
It is suitable for the atmosphere or the environment in which it is to be
used. Coastal applications should be notified to the manufacturer prior
to order.
It is suitable for the working media, temperature and pressure for which
it is to be used.
Electrical equipment is earthed to comply with I.E.E. regulations and
local by-laws.
The procedure for removing and replacing filter media are fully carried
out as set out in th
Important information
This symbol is provided to highlight important additional information.
Caution
This symbol identifies potential situations which could lead to the damage of
equipment.
Danger
This symbol indicates situations which present hazardous conditions, which without
applying strict health and safety procedures can result in serious personal injury or
even death.
Installation, Operation & Maintenance Manual
SAFETY
Check for any treatment that is required to the water supply for prevention of
scaling of equipment. Information regarding the necessary action to
be taken can be obtained from the relevant Water Supply Authority, particulars of
which can be found in the Waters Engineers Handbook yearly edition.
No part of the unit shall be dismantled until a careful study has been made of this
This manual deals in detail with erection, commissioning, and servicing, and shall be
strictly adhered to. Wherever any maintenance or work is done within the unit, the
interior shall be left clean and all access panels and guards shall be correctly
This section deals with the hazards that could be encountered when any work is
carried out on the equipment for which this manual is written. Therefore the
following points should be observed to avoid any injuries or health hazards.
The installation of the unit shall be checked to ensure that:
A suitable electrical supply is connected.
Prior to entry to any section please ensure that the electrical supply
isolated either at the control panel or at the incoming mains. Please note
that if the control panel isolator is switched off the incoming side of the
electric supply will remain live. DO NOT enter the unit while the fans are
running. After isolating the electrical supply wait 2 minutes for the fans
to stop prior to removing fan covers.
It is suitable for the atmosphere or the environment in which it is to be
used. Coastal applications should be notified to the manufacturer prior
e for the working media, temperature and pressure for which
Electrical equipment is earthed to comply with I.E.E. regulations and
The procedure for removing and replacing filter media are fully carried
out as set out in this manual.
Important information
is provided to highlight important additional information.
This symbol identifies potential situations which could lead to the damage of
This symbol indicates situations which present hazardous conditions, which without
ng strict health and safety procedures can result in serious personal injury or
Check for any treatment that is required to the water supply for prevention of
uipment. Information regarding the necessary action to
be taken can be obtained from the relevant Water Supply Authority, particulars of
No part of the unit shall be dismantled until a careful study has been made of this
This manual deals in detail with erection, commissioning, and servicing, and shall be
or work is done within the unit, the
interior shall be left clean and all access panels and guards shall be correctly
This section deals with the hazards that could be encountered when any work is
carried out on the equipment for which this manual is written. Therefore the
following points should be observed to avoid any injuries or health hazards.
Prior to entry to any section please ensure that the electrical supply is
isolated either at the control panel or at the incoming mains. Please note
that if the control panel isolator is switched off the incoming side of the
electric supply will remain live. DO NOT enter the unit while the fans are
he electrical supply wait 2 minutes for the fans
It is suitable for the atmosphere or the environment in which it is to be
used. Coastal applications should be notified to the manufacturer prior
e for the working media, temperature and pressure for which
Electrical equipment is earthed to comply with I.E.E. regulations and
The procedure for removing and replacing filter media are fully carried
This symbol identifies potential situations which could lead to the damage of
This symbol indicates situations which present hazardous conditions, which without
ng strict health and safety procedures can result in serious personal injury or
