7
Installation, Operation & Maintenance M
fgfgffhfgfggbffgfV11:0212212121
Assembly of Multiple Sections
Pull the two unit sections together along the baseframe at the bottom of the
unit using sash clamps or ratchet s
aid alignment (One section should slot into the other). CAUTION: Before drawing
together, ensure nothing will get trapped in the space between each section.
Once the unit has been pulled
together, install assembly bolts
through the corner fixing plates
on the inside of the unit. For each
corner, tighten the bolts, ensuring
good compression of the foam
sealant/silicone seal on all mating
faces of the frame.
Apply silicone seal to
outside edge to prevent
ingress of water/dirt into the
gap, as highlighted.
2)
3)
4)
Installation, Operation & Maintenance Manual
Apply a seal to the face
of one section. O
include supplied foam or a
large bead of silicone around
the entire inner perimeter of
the aluminium frame, as
highlighted.
Pull the two unit sections together along the baseframe at the bottom of the
unit using sash clamps or ratchet straps/chains, using the internal corner plates to
aid alignment (One section should slot into the other). CAUTION: Before drawing
together, ensure nothing will get trapped in the space between each section.
Once the unit has been pulled
er, install assembly bolts
through the corner fixing plates
on the inside of the unit. For each
corner, tighten the bolts, ensuring
good compression of the foam
sealant/silicone seal on all mating
Apply silicone seal to
outside edge to prevent
ingress of water/dirt into the
If the AHU
roof, seal the gap between the
sections with silicone before
the joining roof cap is fitted.
1)
5)
Apply a seal to the face
of one section. Options
include supplied foam or a
large bead of silicone around
the entire inner perimeter of
the aluminium frame, as
Pull the two unit sections together along the baseframe at the bottom of the
traps/chains, using the internal corner plates to
aid alignment (One section should slot into the other). CAUTION: Before drawing
together, ensure nothing will get trapped in the space between each section.
If the AHU has a pitched
roof, seal the gap between the
sections with silicone before
the joining roof cap is fitted.
