iRelay 460 Equipment Installation Guide
UGD-D01035
Airspan Commercial and Internal Use
7
1.3 Installation Checklist
To plan the installation of the iR460 unit, use the installation checklist. See
Appendix B
.
1.4 Verify Site Requirements
Commissioning iR460
1.4.1
To change or check iR460 values, an Ethernet connection or Bluetooth is required to a laptop PC so
that the local web page can be accessed.
LOS Check
1.4.2
For best results it is important to have a clear LOS between iR460 and the DeNB.
To ensure a clear LOS, make sure the following requirements are met:
Note:
Make sure to check whether there are any additional obstacles which were not detected
during last survey.
1.5 Verify Safety Requirements
Read and follow all warning notices and instructions marked on the product or included in this
manual.
When installed in the final configuration, the product must comply with the applicable safety standards
and regulatory requirements of the country in which it is installed. If necessary, consult with the
appropriate regulatory agencies and inspection authorities to ensure compliance.
Ascertain the radiation hazards and act accordingly when working in an environment close to other
antennas and electromagnetic fields—for example, working on towers with other Radio transmitters.
Warning of Hazardous Voltages
1.5.1
On AC installations, hazardous voltages exist. Use caution when verifying or working with the AC
power. Before working with the AC power, remove all metal jewellery and accessories (for example—
rings, watches, and other metal items). To avoid personal injury or damage to the equipment, do not
allow these metal items to come into contact with the AC power.
On DC sections, short circuiting the low voltage, low impedance circuits can cause arcing that might
result in burns or eye damage. To avoid shorting DC circuits, remove all metal jewellery and
accessories.
Important:
Airspan products do not contain hazardous substances (as defined in UK Control of
Substances Hazardous to Health Regulations 1989 and the Dangerous Substances Regulations
1990). At the end of any Airspan products life cycle, the customer should consult with Airspan to
ensure that the product is disposed of in conformance with the relevant regulatory requirements.
Caution:
Any modifications to this device not expressly authorized by the manufacturer can void
the users’ authority to operate this device.
