En-6
ERROR CODE DISPLAY
The air conditioning system must be inspected if “E
✽
:
✽✽
” (error code) appears on the Timer and Clock Display, or the opera-
tion lamp is flashing. Stop air conditioner operation and please consult authorized service personnel.
OPERATING TIPS
Cooling/heating priority (AIRSTAGE
TM
(V-II Series Heat Pump model only))
•
If another indoor unit in the same system is already ope-
rating in the cooling mode or dry mode, heating mode set-
tings cannot be performed.
•
An indoor unit that is set up as an administrative indoor
unit can operate in the AUTO mode.
Administrative indoor unit:
Special indoor unit is not restricted by the switching of
cooling and heating described above.
It may happen if the unit is set to refrigerant system set-
ting.
TROUBLESHOOTING
Before requesting service, perform the following checks:
Symptom
Does not operate at all.
Items to check
●
Has there been a power failure?
●
Has a fuse of converter blown out, or a circuit breaker been tripped?
●
Is the main power switch set to the OFF position?
●
Is the timer operating?
CHECK ONCE
MORE
If the problem persists after performing these checks, or if you notice burning smells, stop operation immediately, turn off the
electrical breaker and consult authorized service personnel.
SPECIFICATIONS
GROUP REMOTE CONTROLLER (WIRED TYPE)
MODEL
POWER
DIMENSIONS & WEIGHT
HEIGHT
WIDTH
DEPTH
WEIGHT
UTY-CGG
DC 12 V
120 mm (4-3/4 in.)
120 mm (4-3/4 in.)
17 mm (5/8 in.)
160 g (0.35 lbs.)
MONITOR MODE
●
The operation status of each indoor unit can be checked in the Monitor mode.
To enter the Monitor mode
After blinking as
(after transmission), it will switch to Monitor Mode
in 60 seconds automatically. When a key operation is in progress,
is
displayed. *
is not shown in the Monitor mode.
Press the Select button to select an indoor unit to display the current status.
Setting display
•
When a key operation is in progress,
is displayed.
After blinking as
(after transmission), it will switch to
Monitor Mode in 60 seconds automatically.
After the operation is complete,
flashes for a minute,
and then goes off.
•
When
is flashing, it means that the signal is being
transmitted. During this time, key operations are disabled.
•
When
is displayed there are functions for which set-
tings cannot be made.
NOTES
(1) The WEEKLY timer does not operate when the HEAT timer is set if a HEAT PUMP MODEL in the air conditioning system
is operating in the cooling mode. In addition, the WEEKLY timer does not operate when the COOL or DRY timer is set if
a HEAT PUMP MODEL in the air conditioning system is operating in the heating mode.
(2) Even if the timer operation is set, the timer lamp of the indoor unit does not light up. (The timer lamp is used for
wireless remote controller only.)
(3) If the same time is set in Timer-1 to Timer-4 of an indoor unit, the timer setting of the smallest number will be effective.
not shown
Summary of Contents for UTY-CGG
Page 8: ......
