ExTERIOR
D - 8
D
D - 9
When greasing bearings by hand, place a glob of
grease in the palm of one hand and push the large
end of the bearing down into the grease (see illustra-
tion). Keep turning the bearing around and forcing it
down through the grease until the grease is extruded
up through the opposite end. Wipe the extra grease
in your hand around the outside of the bearing. It’s not necessary to fill the hub
and dust cap with grease.
ELECTRIC BRAKES
A CONTROLLER installed in your tow vehicle will synchronize the trailer brakes
with your tow vehicle brakes. It is designed to apply the trailer brakes whenever
the tow vehicle brakes are applied.
TYPICAL ELECTRONIC CONTROLLER
ELECTRONIC CONTROLLERS are inertially activated. The controller senses
deceleration and generates an output, which reflects the inertia sensed. When
you are stationary, the controller does not apply the brakes unless the manual
slide bar is activated.
NOTE: Study all material provided with your particular brake control. If you
don’t understand the information, have the installer explain the information to
you or call the manufacturer of the controller.
In THE EVENT OF AN ACCIDENTAL SEPARATION of the tow vehicle and trailer,
the BREAKAWAY SWITCH will set and lock the trailer brakes for a sufficient
length of time to stop the trailer. The switch is activated when the wire attached
to it and to the tow vehicle pulls out the small pin in the front of the unit. THIS PIN
SHOULD BE PULLED OUT, LUBRICATED WITH LIGHT HOUSEHOLD OIL AND
REPLACED EVERY 90 DAYS.
To prevent corrosion within the breakaway switch, turn you trailer battery
disconnect to “STORE”, pull the switch’s pin straight forward and spray the
inside of the switch through the hole with an electric contact cleaner (such as
Spra-Kleen) and reinsert the pin. A drop of light household oil on the groove
near the base of the pin will allow the pin to operate freely. WHEN THE TRAILER
IS CONNECTED TO THE TOW VEHICLE, THE BREAKAWAY SWITCH LOOP
SHOULD BE ATTACHED TO THE PERMANENT FRAME OF YOUR HITCH.
When disconnecting trailer from tow vehicle remove wire loop from the frame.
DO NOT REMOVE PIN FROM SWITCH BECAUSE THIS WILL APPLY THE
TRAILER BRAKES.
Warning
: Do not use breakaway switch for parking brake or
leave the pin out for longer that a few minutes with the battery disconnect
in the “USE” position.
Summary of Contents for 2013 International
