G - 10
ELECTRICAL
G - 11
G
TV ANTENNA
Manufacturer:
Winegard Company
3000 Kirkwood Street
Burlington, Iowa 52601
Phone: 800-843-4741
Raising Antenna to Operating Position
Turn elevating crank in “UP” direction until some
resistance to turning is noted. Antenna is now in
operating position. Check to make sure switch on
front TV jack is on.
Rotating Antenna
Make sure antenna is in “UP” position. Pull down
on directional handle with both hands until it disen-
gages ceiling plate and rotate for best picture and
sound on television set.
Lowering Antenna to Travel Position
Raising Antenna
Rotating Antenna
Lowering Antenna
Rotate antenna until pointer on directional handle aligns with pointer on ceiling
plate.
nOTiCE
: Antenna must be in “down” position while traveling to prevent
damage.
Turn elevating crank in the “Down” direction until resistance is noted. Antenna
is now locked in travel position.
Checking Operation:
1. Tune TV receiver to nearest station and rotate antenna for best picture and
sound.
2. Turn off switch on booster power supply. Picture on TV receiver should be
considerably degraded with the power off.
DO’S
1. Do check parking location for obstructions before raising antenna.
2. Do carefully raise, lower and rotate - if difficult, check for cause.
3. Do rotate slowly when selecting station and check fine-tuning on TV set
to make sure it is properly adjusted.
4. Do lower antenna before moving vehicle.
Summary of Contents for 2013 SPORT
