F
PLUMBING
F - 7
TOILET
Porta Potti Model 565
Manufacturer:
Thetford Corporation
Customer Relations: 1-800 521 3032
Before each use
With seat cover closed, open and close the hold-
ing tank valve to vent any pressure that may have
built up as a result of heat or altitude. This pre-
vents upward splashing of bowl contents when
toilet is flushed.
Bellows Flush
1. Pullout holding tank valve handle.
2. Push down on bellows to rinse the bowl.
3. Push valve handle all the way in to insure an
odor tight seal.
Simple design
The top section includes the seat, cover, bowl, flushing bellows and a fresh water
storage tank. The lower section is an odor-tight, gas-tight detachable waste holding
tank. The unit is made of high-impact polypropylene and has an “easy care/ easy
clean” finish.
Deodorizing
Use Thetford’s Aqua-Kem liquid holding tank deodorant for maximum deodorizing
performance. Also recommended are Aqua-Kem Green non-formaldehyde deodorant,
Aqua-Kem Toss-Tabs, Aqua-Kem Toss-Ins or Aqua-Kem DRI.
Read and follow all instructions, cautions and warnings on the packaging.
Care
Use Thetford Aqua-Clean. DO NOT USE SCOURING POWDERS, ACIDS OR
CONCENTRATED CLEANERS, WHICH CAN DAMAGE PLASTIC PARTS AND RUBBER
SEALS.
Aside from simple cleaning, Thetford marine heads require no routine maintenance. If
after extended use, the holding tank valve blade begins to stick, apply a light film of
silicone lubricant to the blade.
Refilling Tissue Dispenser
Separate tanks. Rotate the tissue dispenser past its dispense position and unthread it
from the four track pins. Spread the tissue dispenser ends to remove the empty tissue
tube and install the new roll. NOTE: overspreading will result in damage to the tissue
dispenser.
Tissue
Dispenser
Holding Tank
Valve Handle
Level
Gauge
Water Fill
Vent Cap
Locking Latch
Bellows Flush
Assembly
Waste Holding
Tank
Holding Tank
Seal
Vent Button
Pour Out
Spout
Spout
Cap
Fresh Water
Tank