5-18
Thermostat
To turn thermostat on when the black light is off, press
any button to “wake up” the thermostat. Press and
release the - ON/OFF button�
Pressing the MODE button will cycle through the
mode options available� A mode is an operation that
can be performed by the unit and is controlled by the
thermostat� The available modes typically are: OFF,
COOL, HP (Heat Pump), FURN (Furnace), and AUTO�
Press the F/C button to switch between Fahrenheit and
Celsius�
NOTE
The Heat Pump Operation works well only when
the ambient temperature is above 45° F/ 7°C
The FAN button us used to select the fan speed� The
options are: AUTO, HI, MED, or LOW�
NOTE
When using the FURNACE the fan speed should
be set on AUTO. Otherwise the AC fan will
continuously run.
To set the Clock to the correct time, press the CLOCK
button. The “HOUR” digits will flash first. Use the UP/
DOWN arrows to adjust� Press the CLOCK button
again and the “MINUTE” digits will flash. By pressing
it a third time the “AM/PM” icon will flash. Press the
CLOCK button again will store these settings into
memory�
To Do a System Reset/Remove Error Code:
• Make sure the CCC 2 thermostat is in the OFF mode
(either a blank screen or clock only showing)
• Simultaneously press the MODE and ZONE buttons�
The LCD will display “IniT” and all available zones.
• Release the MODE and ZONE buttons�
• Press the ON/OFF button to exit system set up� This
will remove any error code, reset the system, and
allow you to re program the thermostat�
Water Heater
The Caravel is equipped with a continuous water
heater featuring freeze protection, and direct spark
ignition� The tankless water heater monitors inlet water
temperature and flow, and output water temperature
and flow. The water heater is controlled by the Control
Center located on the wall above the bathroom
sink� Turn on the power and press the temperature
selection arrow to see current setting� Select desired
temperature using the up and down arrow� Turn on the
hot water faucet�
The switch used to light your electronic ignition water
heater is located above the galley sink on 16’ models
and in the bathroom on all other models� Normally,
the burner will ignite in just a few seconds unless your
LPG system has not been used for some time and
air has filled the lines. The system will go into safety
lockout, after 3 failed ignition attempts, before the air
is expelled� If this happens and error code of "E1" will
appear on the screen� Turning the Water Heater off for
30 seconds and then back on reinstates the ignition
mode�
Common Error Codes
• E1
: Ignition failure of accidental flame off during
ignition – Check that you have LP in the tanks,
that other LP appliances work, and no debris or
obstruction in the burner�
• E2
: Flame sensing interrupted during normal
operation, a buzzer will sound� Check that you have
LP in the tanks, that other LP appliances work, and
no debris or obstruction in the burner�
Summary of Contents for Caravel 2023
