background image

1. Confirm that the power button on the 

inflator is in the “OFF” (button up) 

position. 

2. To use the inflation accessories, snap 

either piece into the universal adapter 

and push the lever to lock into place. The 

inflation accessory will fit securely.

3.

 Plug power cord into 12V DC power 

outlet.

WARNING

 

For use with any 12V DC 

power outlet rated 15-Amps or higher. Do 

NOT use with older 8-Amp cigarette 

lighter receptacles. 

4. Insert the appropriate inflation 

accessory into the inflatable object (tire, 

football, raft, etc.).

5. 

Hold the (+) or (-) button for 

approximately 5 seconds until the display 

flashes. Set the required pressure using 

the (+) or (-) buttons, then wait 2-3 

seconds. The display will show the 

current pressure value to which the 

object will be inflated.

6. Push the power button to the “on”        

(button down) position for the inflator to 

start. When the pressure gauge reaches 

the pre-set value, the inflator will 

automatically switch off and the display 

will show “OFF”. Press (M), or (+) or (-) to 

restart the compressor after finishing the 

inflation of one object.

FEATURES

oil and grease. Always use a clean cloth 

when cleaning. Never use brake fluids, 

gasoline, petroleum-based products, or 

any strong solvent to clean the inflator.

• Operate the inflator only with the 

attachments that are included. 

• USE SAFETY GLASSES. Also use face 

or dust mask if operation is dusty.

• Your vehicle’s 12 Volt battery must be 

fully charged to get the best performance 

from your inflator. If your vehicle’s battery 

is weak, the inflator will not work at its 

maximum output level. 

• For best results, it is recommended that 

you operate your inflator with your 

vehicle’s engine running.

WARNING:

 DO NOT RUN VEHICLE 

ENGINE INSIDE A CONFINED AREA 

SUCH AS A GARAGE as bodily injury or 

asphyxiation resulting in death can occur. 

ALWAYS ALLOW FOR PROPER 

VENTILATION.

• Most vehicle 12 Volt power outlets will 

operate with vehicle ignition off; however, 

some vehicles require that the ignition be 

turned on.

• THIS INFLATOR IS NOT DESIGNED 

TO FILL AIR TANKS OR AIR SHOCKS.

OPERATING INSTRUCTIONS

• Easy to read illuminated digital display

• Digital pressure gauge let’s you set the 

desired pressure with the press of a 

button

• Long-lasting LED light for night use 

switches between white, red and flashing 

red SOS signal for added safety

• 100 PSI Maximum pressure capacity.

• Inflation accessories included

• 25 in. Hose Length.

• 9.2 Ft. Power cord.

Reviews: