Page 34
aERO MODEL TyPE
TH-CUT setting range is -150% to 0%. The default setting is -100%.
Decreasing the Throttle Cut percentage value will increase throttle servo
travel when the Throttle Cut button is pressed.
Changing the Throttle Cut Percentage Value, Continued....
3) Press the INC+/M1 or DEC-/M2 keys to set the position you would like
the throttle servo to move to when you press the Throttle Cut button.
12.D/R & EXP (DUaL RaTE anD EXPOnEnTiaL)
The SD-6G transmitter features one Dual Rate switch that controls Dual Rate for the elevator, aileron, and rudder channels
at the same time. In addition, the Dual Rate percentage value for each channel can be programmed independently. The
Exponential function is linked directly to the Dual Rate switch, allowing you to program Exponential for each of the two Dual Rate
positions separately. For greater flexibility, both Dual Rate and Exponential can be programmed either the same for all Flight
Modes or separately for each of the three Flight Modes.
Current Channel
Dual Rate Switch Position
Transmitter F-MODE
Programming F-MODE
Transmitter F-MODE refers to the Flight Mode that the transmitter is currently operating in. Programming F-MODE refers
to the Flight Mode that you would like to change the programming for.
Choosing the Flight Mode - Common or Separate
When set to COMMON, the Dual Rate and Exponential percentage values you program will be the same regardless of which
Flight Mode the transmitter is operating in. You cannot program Dual Rate and Exponential percentage values separately for
each Flight Mode. When set to SEPARATE, you can program Dual Rate and Exponential percentage values separately for each
Flight Mode. This allows for greater flexibility.
1) From the Display screen, press the ENTER key to display the Programming
Menus.
2) Press the Navigation Pad
56
to highlight D/R & EXP, then press the
ENTER key to display the D/R & EXP menu. The cursor will default to
D/R>100%.
3) Press the Navigation Pad
5
to move the cursor to F-MODE>COMMON.
4) Press the INC+/M1 or DEC-/M2 keys to choose either SEPARATE OR
COMMON.
5) If you choose SEPARATE, press the F-MODE key to choose the F-MODE number you would like to program the Dual Rate
and Exponential functions for. Choose from FN, F1 or F2.
(Typically 1=Maximum Control Throw
and 2=Reduced Control Throw)
Summary of Contents for SD-6G
Page 1: ...Page 1...
