11
Caring for Your Twister
Your Twister is designed to provide many thousands of hours of working life. By following the listed
procedures you will ensure this happens and protect your investment, up time and warranty.
Every 25 hours
Check fluid levels
Check for loose or rubbing components, leaks, air and fluid
Every 100 hours
As above
plus
Check air filter elements condition
Check fan belt tension
Check fuel filter
Every 250 hours
As above
plus
Service engine and compressor oil and filters
Check radiator hoses and clamps
Check air intake hose
Check hoses for rubbing and/or wear
Check replace belts as required
Every 500 hours
As above
plus
Service engine oil and filters
Check radiator hoses and clamps
Check air intake lines
Replace coupler on engine and compressor
Replace the fuel filter element
Clean the radiator external fins
Replace the fan belt/replace generator belt if required
Check valve lash (see page 5)
500 HR Service Kit Instructions
NOTE: Fuel filter housing requires bleeding after fuel filter change.
a) Turn unit on without starting engine, to run fuel pump
b) Loosen screw on top of fuel filter housing until a steady flow of fuel is seen.
c) Tighten screw, start unit, check for leaks.
Clean up any spilt fuel and dispose of properly
Every 2 years
Replace radiator hoses and clamps
Change radiator coolant
Replace air intake hose
