Airxcel Aqua-Hot Reporter Technical Supplement Download

Page: 5 / 42

©Aqua-Hot®

Aqua-Hot Reporter Install & OEM Supplement

p. 3

Boost Pumps

Boost pump functionality has changed with the

implementation of the Reporter 2.0.

On Reporter 1.0 units, any boost pumps at use within the

coach required a relay connected to wires 3b and 5b in order
to operate.

With Reporter 2.0, that relay can now be eliminated, with

boost pump power and functionality now being handled directly
by the Reporter. Using a ﬂ ag-terminal, connect the boost pump
directly to the harness bearing in mind the requirements below.

• Zone 1: Connect to Wire 3b

Max Current Draw:

5.0A

Over-Current Condition:

8.0A

• Zone 2: Connect to Wire 5b

Max Current Draw:

3.0A

Over-Current Condition:

5.0A

Original Equipment Manufacturers (OEMs) will need to

provide the ground for operating boost pumps from the Reporter.

Electrical Speciﬁ cations:

The Reporter contains a single Amphenol ATP family

connector  that  serves  as  the  power  connection  to  the  coach
side  12V  DC  power  system.  Mating  connection  components
are not supplied by Aqua-Hot. Compatiable part numbers and
manufacturers  are  supplied  below.  The  Reporter  must  be
operated to the below listed speciﬁ cations.

Minimum Voltage.....................................11.0V DC
Maximum Voltage....................................15.0 V DC
Minimum Current.....................................75mA
Maximum Current....................................15A

Please note that the minimum current rating is the minimum

requirement for what will operate the Reporter. Operating
at this current rating will not provide sufﬁ cient power to any
components dependent upon the Reporter.

Input Load currents

Zone Thermostats (each)..................................appx. 1mA
Diesel Burner Switch........................................ appx. 1mA
Electric Element Switch.................................... appx. 1mA
Low-Level Cutoff Switch.................................... appx. 1mA
Control Thermostat (Reporter 1.0)................... appx. 1mA
Tank Temperature Sensor (Reporter 2.0)........ appx. 1mA
Low-Temperature Cutoff Thermostat................ appx. 1mA

Output Load currents

Zone Fans (Reporter 1.0/all).................................3.0A max
Zone Fan 1 (Reporter 2.0)......................................8.0A max
Zone Fans 2-5 (Reporter 2.0).................................5.0A max
Zone Fans (all)......................................................0.25A max
Circulation Pumps (each).......................................2.0A max
AC Relay..................................................................0.5A max
Burner Power..........................................................6.0A max
Burner Master Control............................................2.0A max
Burner Thermostat Control....................................1.0A max

Connection Terminal Information

RVC Mating Connection

Mfg.

Part Number

Description

37104-A165-OOE-MB

RVC Connection Housing

RVC Mating Connection

Pins

Housing

Wedge

Deuthsche