15
ASSEMBLY AND CONNECTION
AIRZONE RADIANT365 MAIN CONTROL BOARD (AZRA6RADIANT)
Assembly
The Main Control Board is delivered for assembling in a device box (65 x 65 mm / Ø65 mm) .
Location and installation of the module must comply the current electronic rules.
For the assembly of the Main Control Board, please follow these steps:
•
Remove the cover from the main base.
•
Once all the connections are set, screw the Main Control Board to the device box and
place the cover again.
Connection
Airzone connection bus connectors
The Airzone connection bus allows you to connect all the internal components independents of the Main Control Board to
control up to 8 zones. These are the elements that can be connected:
-
Airzone Thermostats: Blueface (AZRA6BLUEFACEC), Think (AZRA6THINKC) and Lite
(AZRA6LITEC).
-
Airzone 3 speeds/stages dehumidifier control module (AZRA6CMOD3V).
-
Airzone Radiant365 Control Module for Wired Valves 110/230v VALC
(AZRA6CM1VALC).
It has 1 5-pin terminals to connect the Airzone connection bus. Both star connection and bus
connection are available. Attach the wires with the terminal screws following the color code.
SW1
The main control board can also connect to Airzone wireless elements. These elements are associated by
opening the wireless association module of the Main Control Board. Press on SW1 and wait for the LED 11
to remain red. The wireless association module will be open for 15 minutes.
System reset
: If needed to return to Factory values, hold SW1 until the status of LED D11 changes.
Nº
Description
Airzone connection bus
SW1
Domotic bus
Summary of Contents for 8435418928905
Page 1: ...r e b m u N e g a P d r a o b p il C Installation Manual RADIANT365 AZRA6RADIANT AZRA6CM1VALC...
Page 2: ...1 8 ZONES AZRA6RADIANT AZRA6CM1VALC...
Page 35: ...36 Blueface Think Important Use to confirm and to return...
Page 49: ...50 NAVIGATION TREES NAVIGATION TREE BLUEFACE THERMOSTAT...
