16
ES
EN
FR
IT
PT
DE
SYSTEM INSTALLATION
Before the Airzone system commissioning, please check:
•
The system is going to control works correctly without the Airzone system installed.
In order to install properly your Airzone system, follow these steps:
Make all connections
(see Sections
.
-
Connect the thermostat.
-
Connect the main control board to the unit to control.
-
If necessary, connect the inputs of the main control board to the desired devices.
-
Power the main control board.
Check all the assembly and the connection are correct
Assembly and connection evaluation
.
Configure the system.
If you have any other doubt, check the user manual.
Access all our technical documents and the self-diagnosis section, check the most FAQs,
certificates, watch our videos and read our declaration of conformity at:
ASSEMBLY
MAIN CONTROL BOARD
The main control board is mounted on DIN rail or on wall. This main control board is externally powered at 110/230 Vac. It is
should be placed and mounted in accordance with the current electrotechnical regulations.
Note:
To remove the main control board on DIN rail, pull the tab down to release it.
THERMOSTAT
UNO thermostats are mounted on the wall through a support. It is recommended not to locate it more than 40 meters away
from the main control board. To fix it to the wall, follow these steps:
•
Separate the back part of the thermostat from the wall support.
•
If your thermostat is wired make all the connections, if your thermostat is
wireless insert the CR2450 button battery.
•
Fix the back part of the thermostat to the wall.
•
Place the display on the support once it is fixed.
•
Place the anti-theft rods for additional support (optional).
