11
EN
Command class
Version Non-Secure CC Secure CC
SECURITY_2
1
x
SUPERVISION
1
x
FIRMWARE_UPDATE_MD
5
x
THERMOSTAT_FAN_MODE
2
x
THERMOSTAT_MODE
3
x
THERMOSTAT_SETPOINT
1
x
SENSOR_MULTILEVEL
1
x
NOTIFICATION
8
x
Supporting command class basic
The basic command classes are mapped into the Thermostat Mode Command Class as
required by the protocol specification.
Supporting command class indicator
The Aidoo Z-Wave Plus supports Indicator V3 with Indicator ID 0x50 (identity). When the device
receives an indicator set, the backlight start to blink accordingly the received command.
Implemented Mapping:
Associations
Lifeline group:
Nodes belonging to this group will receive: notifications about device reset and
all other changes.
Notification Command Class
The system implement notification command class with Type: System (0x09) and event:
System hardware failure (manufacturer proprietary failure code provided).
Manufacturer proprietary failure code provided are 2 bytes length (error and warning). The
meaning of these bytes are described into the Air conditioning manufacturer's installation
manual.
Basic Command Received
Mapped Command (Thermostat Mode)
Basic set (0xxFF)
If the last non Off mode was 1 or 2 -> Thermostat Mode(last non
Off mode). Otherwise -> Thermostat Mode (0x01)
Basic set (0xx00)
Thermostat Mode (0x00)
Basic GET
Replay with a basic Report with these meaning:
Basic Report 0x00 if mode is equal to 0x00
If mode different than 0 reply with Basic Report 0xFF
