11
EN
EN
FR
IT
PT
DE
•
Devices: It displays the elements connected to the system.
•
Webserver (Only for system 1 Main controller): firmware, IP address, gateway, MAC and PIN.
•
Warnings and errors on system.
Clean screen
: Select this option to clean the screen. The touch screen will lock for a few seconds.
Zone Settings
Press on the icons to access the parameters.
Timer.
It is an auto power-off timer of the zone:
Off.
Timer is not activated.
30.
It activates the timing and switches off the zone after 30 minutes.
60.
It activates the timing and switches off the zone after 60 minutes.
90.
It activates the timing and switches off the zone after 90 minutes.
Heating stages
. The available parameters are:
Air: Only uses air stage.
Radiant: Only uses radiant air.
Note:
For security reasons, the zone will turn off after changing any setting.
Lite Settings.
To save energy, enables to configure the wired Airzone Lite to switch off after a few seconds.
Note
: To access the Lite settings, go to a zone controlled by a wired Lite controller through the zone navigation menu.
WARNINGS AND ERRORS
Controller displays all the system warnings on the screensaver. If there is any error, it will be displayed on the screensaver, on
the main screen and on “Errors”, in user settings.
Warnings
Unoccupied Override.
A zone has been activated while the user mode is set on
Unoccupied. If the set-point temperature is changed, it is maintained for the pre-
established period of time (60 minutes by default) and returns to the set-point
temperature of the unoccupied mode.
Vacation Override.
A zone has been activated while the user mode is set on
Vacation. If the set-point temperature is changed, it is maintained for the pre-
established period of time (60 minutes by default) and turns off the zones again.
Window.
The air conditioning of the zone has been suspended due to open
window. Only available if the window contact of the system is activated.
Occupancy.
No occupancy has been detected in the zone for the last 5 minutes.
Therefore, the timer is activated (the zone will switch off after 90 minutes). Only
available if the presence contact is activated.
Global ventilation.
The global ventilation is activated.
Anti-freezing.
It will be only displayed when it is activated.
Lite Low Battery.
Displayed when Lite interfaces have low battery. It has 2 weeks
of life left in normal conditions.
Heat supply activated.
The Heat supply of the cool mode is activated.
Lite without Main ID.
Lite controller without main ID configured.
Summary of Contents for AZPRBLUECOSG
Page 1: ...1 User s Manual Fran ais Fran ais Espa ol English...
Page 53: ......
