30
ES
EN
FR
IT
PT
DE
INCIDENCES
If an error message is shown, you can check both the Installation Manual and the Self-diagnosis section. Please visit Myzone
web:
APPENDIX
SYSTEM RESET
If you want to return to factory values, press and hold SW1 until LED D11 stops blinking. Wait for the
LEDS to go back to their normal state before starting with the initial configuration process.
ZONE RESET
Blueface and Think thermostats reset
If needed, to reset a zone follow the steps shown in the section
for Blueface and Think
thermostats and the section
if using Lite thermostats.
Lite thermostat reset
If you want to return your Lite thermostat to factory values, pull down all the microswitchs and reinsert the thermostat in its
base. The LED
will flash green twice when the reset process is completed.
CHANGING BATTERIES
To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
Important:
We recommend using of top-brand batteries. Using low-quality
batteries may reduce the duration of use.
Remember to deposit the old battery into an appropriate recycling point.
Note:
Do not forget to remove the security system before taking away the
thermostat from the wall.
Summary of Contents for AZRA6BLUEFACECB
