20
ES
EN
FR
IT
PT
DE
Operation Mode
Displays the operation mode of the system. Press to access the selection menu. Depending on the installation, the available
modes are:
Ventilation.
The system works exclusively in ventilation mode when the zone is active.
Cool.
The system works exclusively in cooling mode when the zone is generating demand (SetpointT < roomT).
Heat.
The system works exclusively in heating mode when the zone is generating demand (SetpointT > roomT).
Dry.
Only available in Direct Expansion systems. The system works in dry mode, refreshing the zone (reducing the humidity)
when any of the zones is generating demand (Setpoint T > room T).
Fan Speed
Note
: This option is not available on installations with dampers control.
On fancoil systems, it is used to set the speed of the AC unit fan. The speed is set in automatic mode by default:
High speed.
Medium speed
.
Low speed
.
Automatic speed
.
On direct expansion units, enables to directly select the speed of the unit, setting the value 1 as the lowest speed
. The
speed is set in automatic mode by default.
ADVANCED USE OF THE BLUEFACE THERMOSTAT
User Settings
This parameters control and change all the basic functionalities. Touch once to display the shortcuts.
Language.
Select your language.
Brightness.
You can set the brightness intensity and activate or deactivate the screen brightness while the screensaver is
displayed or not.
Date and time.
Press on the clock to set the time, the format type (12 or 24 hours) and if you want the system to change the
time automatically. Press on the calendar to set the date.
Clean screen
: Select this option if you want to clean the screen. The screen will lock for a few seconds in order to help you
clean it.
Screensaver
. You can define the information displayed on the screensaver. Depending on your system configuration, you can
select:
•
State of the zone: it displays information about the state and configuration of the zone.
•
If you disable the information option, only the time and state will be displayed.
Information.
This parameter provides information about the zone: type of thermostat, thermostat’s firmware, type of main
control board, main control board’s firmware and status of the communications.
