36
ES
EN
FR
IT
PT
DE
ADVANCED SETTINGS – THINK THERMOSTAT
To access the advanced configuration menu of the Think thermostat, follow the following steps:
•
Associated outputs.
It displays and allows you to select the control outputs associated with the thermostat.
•
Thermostat settings.
Use this parameter to define the thermostat as Master or Zone.
*Note:
It cannot be configured as Master if there is already another Master thermostat.
•
Mode menu.
The thermostats can be set in Basic or Advanced mode. They are set in advanced mode by default. These
are the parameters you can control in basic mode:
-
On/Off.
-
Set-point temperature.
-
Local ventilation.
-
User settings.
If you need to reset the thermostat to advanced mode, access the advanced configuration menu and then activate the
advanced use mode.
•
Offset.
Allows you to correct ambient temperature that is measured in the various areas or in all of them, due to
deviations by sources of heat/cold nearby, with a correction factor between - 2,5˚C and 2,5˚C in steps of 0,5˚C. It is in
0˚C by default.
•
Weight.
This option is used to set the weight of each zone for purposes of determining system operation. The weight
of the zone will be used for calculating the mode (auto-change over) or for calculating heat demands when using
auxiliary heat. Options: Auto or Manual.
o
Auto
(by default). The weight of each zone is automatically assigned based on the number of zones.
o
Manual.
Enables to manually define the weight of the zone. Values: 0 to 100.
•
Reset thermostat.
Resets the thermostat returning to Setup menu (
see section Initial configuration
INCIDENCES
If an error message is shown, you can check both the Installation Manual and the Self-diagnosis section. Please visit Myzone
web:
Press and hold
Press and hold
Press once
Summary of Contents for AZZS6AERST
Page 2: ......
Page 30: ...30 ES EN FR IT PT DE Think Important Use to confirm and to return...
Page 111: ......
