29
ES
EN
FR
IT
PT
DE
Zone reset
If needed, to reset a zone follow the steps shown in the section
thermostats and the section
if using Lite thermostats.
System reset
If you want to return to factory values, press and hold SW1 until LED D19 stops blinking. Wait for the LEDS
to go back to their normal state before starting with the initial configuration process.
Changing batteries
To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
Important:
We recommend using of top-brand batteries. Using low-quality
batteries may reduce the duration of use
.
Remember to deposit the old battery into an appropriate recycling point.
Note:
Do not forget to remove the security system before taking away the
thermostat from the wall.
ASSEMBLY AND CONNECTION EVALUATION
Check the following aspects:
-
The state of the LEDs of the main control board and the
rest of control elements. Check the self-diagnose section
of the data sheet of the elements.
-
Main control board LEDs of opening dampers light up
sequentially.
-
Wired and wireless thermostats power supply.
Important:
In the Main Control Board, check the correct
performance of D3, D11 and D19 LEDs and motorized
elements.
Meaning
D3
Main control board
activity
Blinking
Green
D11
Main control board power
Solid
Red
D19
Association channel active
Solid
Red
Open dampers
Solid
Green
Close dampers
Solid
Red
Summary of Contents for EASYZONE AZEZ6FUJST
