20
ZCSI
:
Z
one
C
ontroller
S
leep
I
nput. When the customer decides to use a motion detector to
add another level of efficiency to the air conditioning system, this parameter has to be
activated in the Master Zone control module. The possible settings for this parameter, are
Off
(default, no motion sensor attached),
NO
Motion Sensor attached, Activates when
closing the circuit,
nC
Motion Sensor attached, Activates when opening the circuit
ZCrI
:
Z
one
C
ontroller
R
emote
I
nput. When the customer decides to use a door or window
contact detector to add another level of efficiency to the air conditioning system, this
parameter has to be activated in the Master Zone control module. The possible settings for
this parameter, are
Off
(default, no remote contact sensor attached),
NO
Door Contact
Sensor attached, Activates when closing the circuit,
nC
Door Contact Sensor attached,
Activates when opening the circuit
Sbdt
:
S
tand
B
y
D
isplay
T
emperature. This parameter allows to select if the thermostat will
normally show the ambient temperature
(parameter value
At
)
or the set point temperature
(parameter value
St
)
OFSt
:
Offset. This parameter allows the Installer to adjust the zone temperature reading and
display in a range from -5
̊
F to 5
̊
F.
The following are read only parameters that allow the service person to know the firmware
version of all components in the system.
zCfV
Z
one
C
ontrol Module
F
irmware
V
ersion
ZtfV
Z
one
T
hermostat Firmware
V
ersion
SCfV
S
ystem
C
ontroller
F
irmware
V
ersion (Airzone Controller)
9. THERMOSTAT
9.1 General Description
The Touch Thermostat, is the access panel for the installer to configure the Zone control
module, and also, for the user to change the temperature setting for the zone and configure
time scheduled set points.
There are no push buttons, jumpers or any mechanical hardware in the thermostat. The only
access to the thermostat is its touch panel screen.
The thermostat measures the ambient temperature, and stores the zone’s time schedule set
points.
If the thermostat is set to OFF, it will normally have the dampers closed. However, when the
IQ Controller sets the operation to wide ventilation mode, enters into calibration mode, or if
the Zoning is disabled from the IQ Controller, all dampers will open regardless if the
thermostats are ON or OFF
In general, the following considerations must be taken into account for thermostat location:
Summary of Contents for iQ Zone
