36
LITE CONTROLLERS
To configure a Lite controller, follow these steps:
Wired Lite controller
-
Perform all the appropriate connections.
-
Connect the controller.
-
Press the LED
to confirm the association.
-
The number of the zone which associates with the controller is the lowest free available number.
-
If the association is correct, the LED
will flash green 5 times.
Wireless Lite controller
-
Open the wireless association channel of the main board, wait a few seconds so the zone module, which will be
associated to the controller, opens its wireless association channel (the wireless opening LED must be solid red).
-
Insert the battery to supply the controller.
-
Press the LED
to begin the wireless search. The LED
will blink in green.
IMPORTANT:
The controller will display first the wireless zone modules which are closer to it. Remember to configure
this controller near the wireless zone module to associate for greater comfort.
-
The module which will be associated to the Lite controller will begin to make a “beep” for its identification. The LEDS
will show the signal level of this module:
o
Low signal range level (It is not recommended to perform the association).
o
Medium signal range level.
o
Good signal range level.
o
Excellent signal range level.
-
Press the LED
to confirm the association, otherwise use
to select another module.
-
The number of the zone which associates with the controller is the lowest free available number.
-
If the association is correct, the LED
will flash green 5 times. If it flashes red twice, it means the controller is out of
range.
