33
INITIAL SETUP
Once the system has been installed and all the elements are correctly connected, power the system for its setup.
Follow the steps described in the following sections to configure all controllers.
Important:
Before performing the initial set up of the system, configure firstly the secondary zones, see
Secondary Zones
Settings
section.
Note:
It is recommended to firstly set the controllers which are going to be configured as main.
BLUEFACE AND THINK CONTROLLERS
Important:
Once the setup has been started, it must conclude. You will be able to modify the desired parameters later.
Language
Select your language. These are the available languages: English, French and Spanish.
To associate a wireless Think controller, start the radio channel search:
Setting wireless device
-
Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once
open, you have 15 minutes to make the association. If that period of time expires, start the
process over again. Remember not to open more than one module at the same time, it may
alter the process. You can also open the channel association radio through the Blueface (see
section
IMPORTANT:
Do not to open more than one radio channel at the same time, it may alter the
process.
-
Start the radio channel search, to do so, press Airzone to start the search.
-
The controller will display the different wireless zone modules found, with the signal level of each one of them. Select
the wanted module and press “Check”, the selected module will begin to “beep” to be identified. Verify
the range is
correct
(30% minimum) and confirm.
IMPORTANT:
Before, selecting the zone module which will be associated with the controller, check that this module is the desired
one. If this module is not the correct one, use the control bar to select another module and check again.
IMPORTANT:
The controller will display first the wireless zone modules which are closer to it. Remember to configure this controller
near the wireless zone module to associate for greater comfort.
Units
(only if it has not been previously configured by any controller)
Select the units you want to use: Celsius (˚C) or Fahrenheit (˚F).
Zone ID
Select the zone associated to the controller. All the zones have a corresponding control output (output for motorized elements
or relay radiant heat control module). For example, the zone 1 will control the control relay output O1 of the relay radiant heat
control module.
Linked zones
(only if there are previously configured secondary)
If necessary, the system allows you to associate more than one control output to a zone. It is possible to control multiple outputs
from the same controller.
Important:
You must select the zone/s that you want to configure as secondary outputs before pressing "Confirm”.
Controller settings
Select the operation of the controller:
-
Main: Controls all the parameters of the installation.
-
Zone: Controls all the parameters of the zone.
Fig. 61
