39
Heating stages *
. The available parameters are:
Air
: Only uses air stage.
Radiant
: Only uses radiant air.
Air+Radiant
: The system combines both stages to reach comfort quickly and efficiently.
Note:
For security reasons, the zone will turn off after changing any setting.
* Available based on the installation and system setting.
Lite Settings.
To save energy, enables to configure the wired Airzone Lite to switch off after a few second.
Note
: To access the Lite settings, go to a zone controlled by a Lite controller through the zone navigation menu from the Blueface
controller connected to it.
THINK CONTROLLER
Remember:
Use
to confirm and
for going back if browsing submenus.
Setting Parameters
Press
to access the menu:
Operation Mode.
This parameter is only available when the Think controller is configured as main, the available modes are:
Cool.
The conditioning unit will start a cooling cycle any time that any zone is in cool demand (T
Set-Point
< T
room
).
Heat.
Enables the heating cycle whenever a zone is in heating demand (T
Set-Point
> T
room
).
Auto.
The Auto mode allows automatic switching between cool and heat, depending on the global demand.
Dry.
In this mode, the air-conditioning unit will start a dehumidification cooling cycle any time that any zone is under
demand (T
Set-Point
< T
room
).
Note
: Dry mode decreases humidity in the room by entering the dehumidification cooling cycle.
Emergency Heat.
This mode activates the Auxiliary Heat to provide heated air in case of a mechanical failure in the system.
Note:
This mode is only visible when the installation includes an auxiliary heating device.
User Mode
Airflow/Fan speed
Control bar
Current Set Point
Timer
On/Off
Home screen/ Heating
or Cooling Set Point
temperature
Local ventilation
Zone demand
Setting parameters
Zone/ Current Room
Temperature/ Relative
humidity
Operation Mode
