12
EN
FR
ES
IT
PT
DE
Remember:
Once all the connections are made, make sure you replace the cover properly.
Zone reset
If needed, to reset a zone follow the steps shown in the section
, for Blueface and Think controllers and the
section
if using Lite controllers.
Reset the system
If you want to return to factory values, press and hold SW1 until LED D19 stops flashing. Wait about 1
minute approximately for the LEDS to go back to their normal state before starting with the initial
configuration process.
Replacing batteries
In order to replace the battery, please remove the controller from its support
and then replace it (CR2450).
Important:
We recommend the use of top-brand batteries. Using low-quality
batteries may reduce the duration of use.
Remember to deposit the old battery into an appropriate recycling point.
ASSEMBLY AND CONNECTION EVALUATION
Check the following aspects:
-
The state of the LEDs of the control board and the
rest of control elements. Check the self-diagnose
section of the data sheet of the elements.
-
All controllers are powered.
Important:
In the Control Board, to verify the correct
performance, check D3, D11 and D19 LEDs.
Meaning
D3
Control board activity
Blinking
Green
D11
Control board power
Steady
Red
D19
Radio channel: active
Steady
Red
